Blackout roller blind fabric width 70 cm off-white

Blackout roller blind fabric width 70 cm off-white Roller blind installation instructions When you receive an OKU roller blind from your dealer, the spring is not pre-tensioned. With the brackets supplied with the package, the curtain can be installed either on the wall or on the ceiling. When installing, it must be taken into account that the brackets do not press on the curtain. There must be a gap of 1 mm between the pipe and the brackets. Note! OKU roller blinds must never be greased! Follow the instructions below when installing. Installation instructions:>> Installation instructions spring-operated roller blind Brackets can be installed on the wall or ceiling, the bracket on the right is installed as a mirror image. 1 A Wall installation 1 B Ceiling installation 2 Place the curtain on the brackets. 3 Pull the curtain down about a meter to tighten the spring. 4 Take the curtain from the brackets and roll it by hand. 5 Put the curtain back on the brackets and test that the spring is taut enough. Otherwise, repeat steps 3 and 4. If the curtain becomes too tight, remove it from the brackets and wind the fabric slightly downwards by hand. Place the curtain back on the brackets and pull up.